自動飽和蒸汽壓測試儀

（雷德法，小氧彈）

AVP-30D

AVP-30D series carries out the Reid Vapor Pressure test prescribed in ASTM D323 and IP69, AVP-30D has been developed after its well received predecessor, AVP-21D/22D series, with further enhancement in the electronics. The new features include easy switch between display in kPa and kgf/cm2 units, water level monitor for safety, and communication capability with external computers.

AVP-30D適用于ASTM D323（石油產品蒸氣壓力的標準測試方法(Reid法)）和 IP69的試驗。儀器應用了“日本田中科學機器制作株式會社”前2代產品發展而來的新技術，大顯示屏可按需要自動換算顯示kPa和 kgf/cm2兩種單位。浴槽水位保護的細節設計。還可與計算機通訊傳送測試數據,便于集中控制管理。

EASY HANDLING:

Compact size bombs allow easier handling, yet yielding the same test results compared to the heavy full size bombs. (The V/L ratio of 4 is maintained, and therefore equivalent test result is obtained). Note- The suffix “D” followed by “AVP-30” stands for “Demi size. ”

AVP-30D型自動飽和蒸氣壓試驗儀采用小型試樣壓力樣彈。由于蒸氣壓力樣彈的長度和容積是標準雷德壓力樣彈體積的正比例縮小（分別為60%和30%），能較快而正確的測定雷德飽和蒸氣壓力。而型號中的“D”，則表示氧彈大小是為標準所規定的“Demi size. ”。

COMPACT SIZE:體積小

Width is merely 400mm, and the footage on the lab bench is at minimal.

儀器寬度僅400mm可放置于試驗臺上。

PRECISE RESULTS: Semiconductor type vapor pressure sensor and reliable/efficient see-saw shaking mechanism are employed. The semiconductor sensor is extremely stable, yielding consistent test results.高精度的壓力傳感器，以獨特的振動方式自動測定雷德飽和蒸氣壓力。獨有的快速接口設計，安裝簡單，拆卸方便。

TRACEABLE: 儀器校驗

The pressure sensor can be calibrated easily using a Mercury Manometer (Optional).

儀器可以很容易的應用汞柱（水銀）壓力計對氣壓傳感器進行校驗。另：儀器出廠時全部調整完畢，通常無需再調整。

AVP-30D-4bombs & Mercury Manometer

如圖所示，AVP-30D（4氧彈型）+汞柱（水銀）壓力計

TANAKA Automatic Vapor Pressure Tester, model AVP-30D

SPECIFICATIONS:

RELATED STANDARDS: （適用標準）

ISO 3007, ASTM D323, IP69 etc. GB/T 8017

TYPE:

Bench-top with 2,3, or 4 Demi-size bombs 

Pls. Indicate number of bomb when ordering

Automated continuous shaking of test bomb by “see-saw” motion. 

MEASURING RANGE: （測試范圍）

0 to 196 kPa (2kgf/cm2)

TEST BOMBS: （測試氧彈）

Small size stainless steel bombs with 66% in length and 31% in volume compared to the regular full size bombs. The V/L ratio of 4 is the same as full size bomb. A ”Quick Coupler” is equipped at the center of the vapor chamber for connecting to external pressure sensor located inside of the tester

等比例小型氧彈，長度是原標準的66%，體積減少了31%。每個氧彈中部都配有獨有設計的“快速接頭”，通過導壓管與測試傳感器連接。

PRESSURE SENSOR: 壓力傳感器

Semiconductor type pressure sensor. Range: 0 to 196kPa (2kgf/cm2)

測試范圍：0 to 196kPa (2kgf/cm2)

Linearity: <0.3% of the range Hysteresis: <0.3% of the range 線性和滯后性均小于<0.3%

DISPLAY: 顯示屏

LCD with back light Pressure display range: 0 to 200kPa or 0 to 2kgf/cm2

帶背光顯示的LCD，按需要自動換算顯示kPa和 kgf/cm2兩種單位

SHAKING: 震蕩板

By “see-saw” movement with angular movement of +/-15 degrees and interval of 6 sec

類似于“蹺蹺板”的震蕩板機構。每6秒，按±15度上下震蕩氧彈，勻速氧化反應。

BATH: 浴槽

Temp control: Digital controller/display with PT-100 sensor Precision: +/-0.1℃

Stirring: By propeller driven by motor Heater: tainless sheathed heater 1.15kW

全不繡鋼制，帶攪拌，PT-100傳感器，控溫精度±0.1℃。加熱功率1.15kW。

CALIBRATION: 校正

By connecting a mercury manometer (optional) to the pressure sensor

需外接標準汞柱（水銀）壓力計對氣壓傳感器進行校驗。（選購件）

SAFETY MECHANISM: （安全保護）

Water level monitoring device for preventing overheating due to low water level

水位保護設計，避免加熱引起的水面降低。

DATA OUTPUT: （數據輸出）

RS-232C 1 channel (for PC or Optional Printer) RS-232C 接口，1，可連接電腦或打印機

DIMENSION & WEIGHT: （體積/重量）

400W x 600D x 720H (mm), 

50kg when dry, 85kg when filled with water 空機50kg，加水后約85kg

INSTALLATION SITE: 環境要求

Ambient temperature: 0 to 40 oC RH: Less than 90%(no condensation)

室溫0～40℃/ 濕度90%以下（無凝結）

POWER SUPPLY: 電源需求

AC100/120V or  220/240V 50/60Hz (set at the factory)定購事先說明，zui大功率1.5kW(max.)

ORDERING INFORMATION:

STANDARD ACCESSORIES: （標準附件）

	2-bomb	3-bomb	4bomb
1.    Test Bombs測試氧彈	2 sets	3 sets	4 sets
2.    Thermometer ASTM-18C 溫度計	1 pc	1 pc	1 pc
3.    Spare Packing for Bombs氧彈密封墊片	4 pc	6 pc	8 pc
4.    Spare Fuse保險絲	1 pc	1 pc	1 pc
5.    Water Hose, 2m 水管	1 pc	1 pc	1 pc
6.    Water Hose Band 水管夾	1 pc	1 pc	1 pc
7.    Silicone Plug No.3 硅橡膠塞No.3	1 pc	1 pc	1 pc
8.    Connecting Pipe with Teflon Fittings連接軟管	2 sets	3 sets	4 sets
9.    Air Pipe導壓管/氣管	1 pc	1 pc	1 pc
10.   Pressure Releasing Jig 瀉壓閥	1 pc	1 pc	1 pc
11.   Instruction Manual使用說明書	1 copy	1 copy	1 copy
12.   Quick Coupler 1S快速接頭1S	1 pc*	1 pc*	1 pc*
13.   High Pressure Hose, 3m壓強管/倫巴管	1 pc*	1 pc*	1 pc*

*: These items are not includes when ordering together with mercury manometer

*: 配合外接汞柱（水銀）壓力計的配件，如已經訂購了壓力計，則包括在選購件附件內。

OPTIONAL ACCESSORIES: （推薦附件/選購件1）

Mercury Manometer, Single Glass Tube Type 單管汞柱（水銀）壓力計

0 to 100kPa or 0 to 147kPa with 0.2kPa division（0-100或0-147 kPa兩種規格，分度0.2kPa）

Air Compressor for Mercury Manometer, 0.2P-5S

Printer, BS-80TSL with Connecting Cable 外接打印機（帶連線）

SUGGESTED SPARES FOR 2 YEARS: （選購件2，2年維護用）

1 Thermometer ASTM-18C 溫度計（ASTM-18C標準）	1pc
2 Spare Packing for Bomb 氧彈密封墊片	5pcs/bomb
3 Fuse MHS-10A(100/120V) or  MHS-20A(220/240V) 保險絲	1pc
4 Connecting Pipe with Teflon Fittings 連接軟管	1set/bomb